FORTUNA FTM 200 7.5 V1.0.0.0

Moin moin love community,

Version 1.0.0.9
Rail trailer:
Weight reduced
More stability from the dolly and the drawbar
Slipping of the dolly reduced to a minimum. (as soon as the container was secured, it began to slide while standing)

Today I present you the Scania HKL with all the trimmings.
The trailer is as appropriate in the LS17.
The ITR containers that fit on the trailer have been included and there are no complications with the ITR Pack.

The control for the Scania:
K = retract hook
M = extend hook (while the container is being loaded onto the trailer, you can extend the hook so that the truck does not lift off)
J = lower body
N = lift body
This control ONLY serves to get to the container ran without lifting the rear.
If you have the container coupled you can leave everything to the automatic and press X as usual.

The controller for the trailer:
Hold left Shift!
K = Pull Container Attacher to the fron
Pull M = Container Attacher to the rear
If the container is coupled, decouple, move attacher so that he is out of range and only then you can decouple the trailer.
You can position yourself with the container exactly where you would like it.
Motor Config consists of the R730 and the chip tuning.
Tire Config consists of a steering axle and without. both Lizard Road and that stays that way!
You can buy bullfighters
Tires and truck Farbwahlt is of course also there.

Modell:Ap0lLo
Textur: Dimanix LS15
Script: Ap0lLo
Idee / Konzept: Ap0lLo
Tester: Ap0lLo

Change Log v1.0.0.1:
Corrected 5th axle group not recentering when fold/unfold is pressed
This trailer can haul up to 110 short tons (220,000 lbs, 99,790kg)
Usable deck length is 28’, but can be extended up to an additional 28’. It weighs 114,100 lbs (51,755 kg)

Features:
Jeep:
Independent color selection for inner and out frame
Configurable position for bridge attachment point.
All hoses modeled either through dynamic hoses or 3d model

Front Bridge:
Independent color selection for inner and outer frame
Manually steerable wheel group (considered 2nd group)
Auto recenter by pressing fold/unfold key/button
All hoses modeled either through dynamic hoses or 3d model

Front Gooseneck:
Independent color selection for inner and outer frame
Hydraulic tower movable by right mouse axis up/down
Configurable flood lights (forward facing, rear facing, or both)
All hoses modeled either through dynamic hoses or 3d model

Main Trailer:
Independent color selection for inner and outer frame
Hydraulic tower movable by right mouse button up/down
Configurable flood lights (forward facing, rear facing, or both)
Auto steer axle groups 3 and 5
Manual steering of axle groups 3 and 5
Auto steering recenter using fold/unfold key/button
All hoses modeled either through dynamic hoses or 3d model
Configurable deck extensions (7 ft, 14 ft, 21 ft, and 28 ft)
Configurable outriggers for all deck lengths

Transport Mode (works best with deck extensions):
1. remove gooseneck from main trailer
2. Drive jeep and bridge onto main trailer
3. Disconnect from Jeep
4. Go to main trailers steering platform and enter trailer
5. use middle mouse button (AXIS_FRONTLOADER_TOOL5) to flip king pin below deck front and to lower collision which will allow you to attach a truck underneath.
6. Attach main trailer to truck
7. raise collision
Do steps in reverse to make trailer ready for loads.

Jeremy Brown and Jordy Johnson

IH 660 tractor with options for a cab a radio and a guard.

TPF, Scooters Workbench, Oldiron, Giants, PattonM47

Fun mod, no detailed interior, can be made a gasser dragster and pop wheelie everywhere, the rest is as usual, have fun ! .. to do wheelie, you need both the wheel config and engine config as “gasser” tap the accelerator a cople time a bit and when the front start to bounce, floor it!

SebCroteau

Toivila Forest Map. Here is a little map called Toivila here is a lot of felled area and a lot of forest and a small village this is in progress and the test version for you of this is maybe sometimes v2 where i do a lot more all sorts of new things and fix some stuff. in this experimental version of the map this is therefore not quite the final map made. here the map does not work with the seasons. but, be sure to decompress this map because if you have this map packed it will not work properly and some buildings and forests may therefore appear white. be sure to decompress this map that it is in the folder fs19 in the folder decompressed. the map works best when extracted and put it in a folder called Public_Work_Company. Let us know if the map has problems with good games on the test map.

Johtaja94